Another Power Distribution Board

I decided it would be nice to have a power distribution board made of wood and sporting Anderson Power Pole connectors on the bench. The PCB and power poles were sourced from SotaBeams in the UK. This is what I came up with.

The connectors have been loaded onto a PCB, a nice piece of dark wood has a dado routered and the back panel is cut to size.

I drilled and cut the back panel to fit the PCB.

Cutting the back panel.

Next, the PCB was pushed into place.

The gaps between the connectors was filled with small off cuts of wood.

Next, I cut a second piece of timber to use as a back panel to the backing board. This will protect the PCB as current will be flowing through the solder joints.

I used a router as a crude milling machine to make a recess on a backing board to cover the PCB from the rear.

Once that had been done it was just a matter of screwing the two backing boards together and dropping the completed assembly into the base. This was also screwed into position. A coat of protective varnish was then applied.

All done.

My new power distribution board ready to be pressed into service.

Advertisements

2 thoughts on “Another Power Distribution Board

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s